Call or Text: (360) 949-2330
Call or Text: (360) 949-2330
Tank, tankless, gas, electric or hybrid. We size it properly, install it to code, and haul the old one away. Free estimates on all jobs.
Licensed, Bonded and Insured · WA License JEREMPL810QE · Owner Operated · Free Estimates on All Jobs
Most people replace a water heater once or twice in the time they own a house, so it is not a decision you get much practice at. The unit you choose affects your energy bill for the next decade, and the wrong size is a problem you live with every morning.
We will tell you what actually suits your house: how many people use hot water, how much space you have, what fuel you already run, and what you are willing to spend up front against what you save later. Then we install it properly and take the old one away.
A leak from the tank body cannot be repaired. The tank has corroded through and needs replacing before it fails completely.
Most tank units last 8 to 12 years. Past that, repairs stop being good value.
If the hot water runs rusty throughout the house, corrosion is usually well advanced inside the tank.
When a repair approaches a meaningful share of a new unit, replacement is the better spend.
Often the tank is simply undersized for the household it now serves.
Older units lose efficiency. A modern unit can cut the standing cost of keeping water hot.
Conventional tank: lowest up front cost, simplest to service, and the right answer for most homes. Gas or electric depending on what you already run.
Tankless: endless hot water and a smaller footprint, higher up front. Best where hot water demand is heavy or space is tight.
Hybrid heat pump: the cheapest to run by a wide margin, but it needs space and a reasonable ambient temperature around it. Worth the maths if the location suits.
We will give you an honest recommendation for your house rather than the unit with the best margin.
A 30 to 40 gallon tank is usually enough.
40 to 50 gallons suits most family homes.
50 to 80 gallons, or tankless if demand overlaps.
Tell us how many bathrooms and how often you run out. We will size it.
Tell us what you have now and what is going wrong with it.
We look at the space, the fuel and the household.
The unit, the work and the number, before anything starts.
Old unit out and away, new unit in, to code.
Filled, purged, tested, and the space left tidy.
Vancouver · Salmon Creek · Hazel Dell · Orchards · Felida · Battle Ground · Brush Prairie · Ridgefield · Camas · Washougal
How long does a water heater installation take?
A straightforward like-for-like tank replacement is usually a few hours. Changing fuel type, moving the unit, or converting to tankless takes longer because the venting, gas or electrical supply has to change with it.
Do you take the old water heater away?
Yes. Removal and disposal of the old unit is part of the job.
Tank or tankless?
Tankless gives you endless hot water and takes up less space, but costs more up front and often needs venting and gas supply changes. For most homes a conventional tank is still the sensible answer. We will tell you honestly which applies to yours.
Is a hybrid heat pump water heater worth it?
It is much cheaper to run, but it needs space around it and a reasonably warm location, so a small closet is usually not suitable. Where the location works, the running cost saving is substantial.
What size water heater do I need?
It depends on how many people use hot water and when. As a rough guide, 30 to 40 gallons for one or two people, 40 to 50 for a family, 50 to 80 or tankless for a larger household.
Do you charge for an estimate?
No. We give free estimates on all jobs.
Can you replace it the same day?
Often, yes, depending on the unit required and what is in stock. Tell us the make and size and we will tell you what is realistic.
Free estimates on all jobs. Licensed, bonded and insured. You deal with Jeremy, start to finish.
Copyright: © 2026 . All Rights Reserved.